[Dec-2021] 300-610 Pre-Exam Practice Tests | Exam Questions and Answers for CCNP Data Center Study Guide

Designing Cisco Data Center Infrastructure Certification Sample Questions

NEW QUESTION 62
An engineer must configure an interface for managing and orchestrating a Cisco Nexus device. The interface must be operational if the data and control planes crash, support IPv4 and IPv6 addressing, and have been access to its own VRF instance. Which interface should be used to meet these requirements?

• A. lookup
• B. Physical interface
• C. management interface
• D. interface VLAN

Answer: C

 

NEW QUESTION 63
Which two naming formats identify target or initiator iSCSI nodes? (Choose two.)

• A. WWPN
• B. OUI
• C. EUI
• D. IQN
• E. WWN

Answer: D,E

 

NEW QUESTION 64
Which protocol prevents fiber failures from causing a Layer 2 loop in a dark fiber DCI?

• A. MCP
• B. BFD
• C. LLDP
• D. UDLD

Answer: D

Explanation:
Section: Network Design

 

NEW QUESTION 65
Which Ethernet to Cisco Fabric Interconnect connectivity configuration is supported when FCoE is implemented?

• A. cross-connections with pinning
• B. vPC that has unified uplinks
• C. VSS that has unified uplinks
• D. Ethernet and unified ports on the same port channel

Answer: B

Explanation:
Section: Storage Network Design
Explanation
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs-manager/116188- configure-fcoe-00.html#anc11

 

NEW QUESTION 66
What are two characteristics of VRF-Lite on the Cisco NX-OS platform? (Choose two.)

• A. VRF-Lite interfaces support MPLS.
• B. VRF-Lite interfaces can be Layer 2.
• C. Overlapping IP addresses are permitted on different VRFs.
• D. Layer 3 interfaces can belong to multiple VRFs.
• E. Interfaces that belong to VRFs can be physical or logical.

Answer: C,E

Explanation:
Section: Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/routers/connectedgrid/cgr1000/ios/software/15_4_1_cg/ vrf_cgr1000.html

 

NEW QUESTION 67
Which two automation requirements can be met by using Puppet? (Choose two.)

• A. Enable clients to pull changes to configuration files.
• B. Provide support for writing new modules in Python.
• C. Enable one-off infrastructure changes to be performed manually.
• D. Push configuration updates immediately to servers.
• E. Enable clients to pull changes without installing an agent.

Answer: A,D

Explanation:
Section: Automation Design
Explanation/Reference: https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series- rack-servers/whitepaper_c11-740103.pdf

 

NEW QUESTION 68
Drag and drop the configurations from the left onto the correct policies on the right.

Answer:

Explanation:

 

NEW QUESTION 69
An engineer is implementing management access to a Cisco Nexus platform. The customer requires a solution that provides isolation between the data and control planes. In addition to management that uses encryption and authentication. The customer will manage the device using both IPv4 and IPv6. Which two components should be used to meet these requirements (Choose two.)

• A. SNMP
• B. SVI interface
• C. Telnet protocol
• D. SSM protocol
• E. mgmt0 interface

Answer: A,E

Explanation:
We are talking about management only, so SSM is out. Since we need to separate between data and control plane, we should use mgmt0 interface, so SVI interface is out. Since we need to use encryption and authentication, this can be done in SNMPv3, while telnet does not support encryption, so telnet is out.

 

NEW QUESTION 70
Refer to the exhibit.

A high-availability setup for iSCSI is designed with the host running iSCSI multipath software. Each IP storage port on the MDS switch exports the same two Fibre Channel target ports with different iSCSI target names.
In this design, how many iSCSI sessions are created from the host so that recovery occurs if any component fails?

• A. 0
• B. 1
• C. 2
• D. 3

Answer: A

 

NEW QUESTION 71
Refer to the exhibit.

The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?

• A. 2240 bytes
• B. 9000 bytes
• C. 2158 bytes
• D. 2000 bytes

Answer: D

 

NEW QUESTION 72
An engineer must build a VXLAN flood-and-learned network. The customer requires the solution to be based on the IETF documented practice in RFC 7348. The solution must use broadcast, unknown unicast, and multicast (BUM) and include the efficient BUM and short BUM replication modes that use only shared trees. Which technology meets these requirements?

• A. MVPN
• B. Bidirectional PIM
• C. PIM sparse mode
• D. PIM SSM

Answer: B

 

NEW QUESTION 73
Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.

Answer:

Explanation:

 

NEW QUESTION 74
An engineer must design a VXLAN EVPN network. The solution should optimize broadcast, unknown unicast, and multicast (BUM) and short BUM replication, and use PIM anycast RP.
Which solution should be included in the design?

• A. ingress replication
• B. PIM dense mode
• C. head-end replication
• D. PIM sparse mode

Answer: A

 

NEW QUESTION 75
A client in a commercial building installs a Cisco blade server in the multitenant Cisco UCS blade infrastructure.
To cut operating costs, the client's data center is shared with other organizations. The client asks an engineer to prevent third parties from accessing their equipment and from accessing BIOS-related information when booting a server.
Which two policies must be used to meet these requirements? (Choose two.)

• A. quiet boot
• B. CDN control
• C. post error pause
• D. front panel lockout
• E. ASPM support

Answer: A,D

 

NEW QUESTION 76
DRAG DROP
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.
Select and Place:

Answer:

Explanation:

Section: Network Design
Explanation
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/virtual_device_context/ configuration/guide/b-7k-Cisco-Nexus-7000-Series-NX-OS-Virtual-Device-Context-Configuration-Guide/ creating-vdc.html

 

NEW QUESTION 77
Refer to the exhibit.

An engineer must assign multiple Fibre Channel IDs to a single port channel. Which two features must be enabled this goal? (Choose two.)

• A. end-host mode feature on the Cisco UCS Fabric Interconnects
• B. SAN Pin Groups on the Cisco UCS Fabric Interconnects.
• C. NPV feature on the Cisco MDS Series.
• D. Smart Zoning feature on the Cisco UCS Fabric Interconnects
• E. NPIV feature on the Cisco MDS Series

Answer: C,E

 

NEW QUESTION 78
......

Cisco Exam Practice Test To Gain Brilliante Result: https://www.examstorrent.com/300-610-exam-dumps-torrent.html

Tested Material Used To 300-610: https://drive.google.com/open?id=1m3n2hMpkWCxCckb-MyZlDqt_oWaE5CXm