2022 Realistic JN0-1362 Dumps Latest Juniper Practice Tests Dumps
JN0-1362 Dumps PDF - JN0-1362 Real Exam Questions Answers
NEW QUESTION 44
You are developing a CoS policy for a service provider core network that In this scenario, which three statements are correct? (Choose three.)
- A. Core routers should use shapers to ensure that customer traffic does not exceed allowed bandwidth.
- B. Core routers should use a common set of per-hop behaviors.
- C. Core routers should use policers to ensure that customer traffic does not exceed allowed bandwidth.
- D. Core routers should use a consistent CoS configuration across the network.
- E. Core routers should use the DSCP markings already set on ingress traffic.
Answer: B,C,E
NEW QUESTION 45
Your company is a large ISP that is upgrading their routers As part of the upgrade project, they want to implement a solution that will improve the effectiveness of their current RTBH solution for handling spoofed IP addresses coming across the WAN.
Which action would satisfy their requirement?
- A. Implement unicast RPF
- B. Implement manual firewall policies
- C. Implement MACsec.
- D. Implement EVPN
Answer: D
NEW QUESTION 46
A customer requests that you design their Layer 3 VPN solution so that all site-to-site traffic goes through a central site, in a hub-and-spoke fashion You must choose between using one or two interfaces on the hub WAN link.
In this scenario, which solution would you use?
- A. Use one interface on the hub WAN link to ensure simplicity, since only a single route target is required across the entire Layer 3 VPN.
- B. Use two interfaces on the hub WAN link to allow traffic to go from the spokes to the hub on one interface and from the hub to the spokes on the other interface.
- C. Use one interface on the hub WAN link, since both hub and spoke sites will require a second VRF for route-leaking purposes.
- D. Use two interfaces on the hub WAN link to reserve one interface for higher Priority traffic.
Answer: A
NEW QUESTION 47
Exhibit.
You are asked to design a solution that will provision a circuit from the corporate headquarters to a remote branch. The circuit must be secure, and must support IGP adjacencies. IPsec has been chosen to secure traffic across the WAN connection.
Referring to the exhibit which statement describes another requirement for this circuit to function correctly?
- A. You must use a service provider Layer 2 VPN to establish routing protocols across the circuit.
- B. You must increase the MTU of the IPsec tunnel to more than 1500 bytes to allow routing updates across the circuit.
- C. You must use a service provider Layer 3 VPN to establish routing protocols across the circuit
- D. You must implement GRE over IPsec to establish routing protocols across the circuit.
Answer: D
NEW QUESTION 48
Your client asked you to design a solution with the requirements shown below.
- Have better traffic engineering for applications across an existing MPLS core.
- Support both IPv4 and IPv6 traffic
- Work with an MX Series core.
- Work with a North Star Controller
- Work with existing IGP (ISIS)
Which feature would you recommend be implemented in this solution?
- A. CoS-based forwarding
- B. segment routing
- C. zero touch provisioning
- D. opaque area LSAs
Answer: B
NEW QUESTION 49
Which two statements are correct about Junos Space Connectivity Services Director? (Choose two)
- A. It is used to design, provision, and deploy MPLS-dynamic, RSVP-signaled LSP, and static LSP services on devices.
- B. It is used to design, provision, and monitor Label Discovery Protocol (LDP) and Border Gateway Protocol (BGP) services on devices
- C. It is used to provide zero touch provisioning (ZTP), which simplifies the deployment of networks by providing policy-driven plug-and-play provisioning and network bring-up operations.
- D. It is used to design and simulate MPLS-TE and LSP routing.
Answer: A,C
NEW QUESTION 50
As a service provider network architect, you are working with a potential customer who wants to replace their WAN, consisting of two data centers, one HQ, and 76 branch offices Due to application latency requirements between branch offices, the customer insists that all traffic must take the most optimal path through the service provider network. The customer intends to encrypt all traffic between customer routers at each location.
Which WAN technology would you propose in this scenario?
- A. Internet as WAN
- B. point-to-point Layer 2 VPNs
- C. H-VPLS
- D. Layer 3 VPN
Answer: A
NEW QUESTION 51
Your applications are migrating from a legacy data center to an EVPN over a VXLAN-based VM environment. A few critical legacy applications not support this environment and must remain on bare metal servers and the applications must be able to access the Internet.
What must be included in the VXLAN design to satisfy these requirements?
- A. VTEP tunneling
- B. nested VM capability
- C. VXLAN gateway
- D. SR-IOV
Answer: C
Explanation:
https://www.juniper.net/documentation/en_US/release-independent/solutions/topics/concept/solutionevpn
-vxlan-understanding.html
NEW QUESTION 52
You must build a portable and customizable template to secure the What are two components of this template? (Choose two )
- A. routing policy
- B. stateful firewall policy
- C. firewall filter
- D. generic policers
Answer: A,C
NEW QUESTION 53
You work for a service provider that currently uses a full mesh of IBGP peers to share EBGP routes. You are concerned about future scalability with this model and have decided to use route reflectors to overcome the scale limitations associated with the full mesh model.
In this scenario, which statement is true?
- A. Route reflectors do not change existing IBGP next hops by default.
- B. Cluster IDs must be configured on all IBGP peers.
- C. Private autonomous system numbers must be configured on all IBGP peers.
- D. Route reflectors readvertise both the active and backup routes
Answer: C
NEW QUESTION 54
You are asked to create a point-to-multipoint DCI that does not overwhelm the data plane with MAC learning traffic.
Which protocol would you use in this situation?
- A. EVPN
- B. VPLS
- C. PPTP
- D. pseudowire
Answer: B
NEW QUESTION 55
Exhibit.
You work for service provider B that wants to implement a hot potato routing policy on the network so that router C uses link C-A to reach service provider A's advertised routes and router D uses link D-B to reach Service Provider A's advertised routes Currently traffic from router C is traversing the core to exit the network on router B.
Referring to the exhibit, what are two design actions that would satisfy the requirements? (Choose two.)
- A. Configure new IBGP neighbors between routers C and A and routers D and B
- B. Configure the route reflector to send multiple copies of a route learned from different IBGP peers to its clients.
- C. Implement BGP-ORR
- D. Implement BGP-LS
Answer: A,B
NEW QUESTION 56
You are asked to provide a design proposal for a service provider's core network. The network consists of both IPv4 and IPv6 addresses and must scale up to 50 core routing devices.
In this scenario, which statement is correct regarding the IGP design?
- A. You must use IS-4S to support both address families.
- B. You can use OSPFv2 to support both address families.
- C. You can use OSPFv2 for IPv4 and OSPFv3 for IPv6 at the same time.
- D. You must use OSPFv3 to support both address families.
Answer: A
NEW QUESTION 57
You are responding to an RFP for a services provider that wants to upgrade their MPLS/LDP network to use traffic engineering.
Which two statements are correct in this scenario? (Choose two )
- A. Segment routing uses LDP for label adjacency making it backward-compatible with LDP.
- B. RSVP-TE requires a controller for bandwidth reservations.
- C. Segment routing requires a controller for bandwidth reservations
- D. RSVP-TE creates session states on core routers.
Answer: C,D
NEW QUESTION 58
Your customer's WAN edge connects to two service providers SP-A and SP-B. The customer is advertising a single /22 subnet to both service providers through EBGP peering sessions. The customer wants to influence inbound traffic to the advertised /22 destination prefix so that it passes through SP-A when both paths are operational.
Which action meets the customer's requirement?
- A. Advertise the prefix to SP-B with a lower MED value than that sent to SP-A.
- B. Advertise the prefix to SP-A with a lower MED value than that sent to SP-B.
- C. Advertise the prefix to SP-A with an origin of unknown.
- D. Advertise the prefix to SP-B with an origin of unknown.
Answer: B
Explanation:
https://www.juniper.net/documentation/en_US/junos/topics/topic-map/med-attribute.html
NEW QUESTION 59
Your WAN links are on a VPLS service from a single service provider. You must verify device configuration power and status in the event of a service outage.
Which two actions provide out-of-band management to your edge routers? (Choose two)
- A. Connect each serial management port to a console server with a cellular Internet connection
- B. Connect each Ethernet management interface to a dedicated switch with traffic routed on its own subnet on the VPLS service
- C. Place management traffic on a separate VLAN on the VPLS service
- D. Connect each Ethernet management interface to a dedicated switch with its own WAN connection.
Answer: A,D
Explanation:
https://www.wti.com/t-remote-console-and-power-management-for-juniper-switches-and-routers.aspx
NEW QUESTION 60
You are designing an MPLS-based network overlay for your environment that use either LDP or RSVP-signated LSPs.
Which two statements are true about these two signaling technologies (Choose two.) Which two statements are true about these two signaling technologies? (Choose two.)
- A. LDP leverages the IGP to find the best path across the network.
- B. RSVP requires the traffic engineering database (TED) to find the best path across the network.
- C. LDP uses EROs to influence the path of an LSP and enable traffic engineering.
- D. RSVP enables an administrator to configure different traffic types to take different paths across the MPLS network.
Answer: A,D
NEW QUESTION 61
Which statement is correct about learning remote host MAC addresses when your DCI is based on EVPN?
- A. Data plane MAC learning by the provider edge (PE) device is performed.
- B. Control plane MAC learning by the provider edge (PE) device
- C. Static MAC configuration on the provider edge (PE) device is perform
- D. No MAC learning by the provider edge (PE) device is performed
Answer: A
NEW QUESTION 62
......
JN0-1362 Premium Exam Engine pdf Download: https://www.examstorrent.com/JN0-1362-exam-dumps-torrent.html